Nema 23 Stepper motor, 1A, 1.8 degree, 2 phase 6 wires

Nema 23 Stepper motor, 1A, 2 phase 6 leads, 1.8 degree, manufacturer direct sale.

Specification

Dimensions: (Unit=mm)

L Max=56mm

Wiring Diagram

Tips: Reasons for out of step of stepper motor

1. The working torque of the stepper motor is not enough and there is not enough ability to drive load.
2. The acceleration and deceleration process for starting and stopping of stepper motor is not sufficient. The stepper motor runs out of steps during acceleration and deceleration process.
3. Power of the stepper motor is not enough, thus the input power of stepper motor is not enough, leading to out of step of the motor.
4. Drive voltage of the stepper motor is not enough or the drive current is too low.
5. Driver or controller receives the signal interference.
6. Load capacity of motor is reduced due to the system resonance of the stepper motor, thus the step out of the motor is caused.
7. Stepper motor driver is not matched with the signal of controller.
8. The gap or the back-and-forth clearance error of synchronizing gear or reducer is not compensated through programming or the compensation value is not correct.
9. There is something wrong with the control programming.